Site icon Bossor Laser

Electric plate shearing machine adopts resistance key form clutch structure and open gear transmission

Electric plate shearing machine adopts resistance key form clutch structure and open gear transmission, and adopts more convenient electric operation, low noise, convenient operation and maintenance. Adopt integral structure, no deformation, easy operation, beautiful appearance, low energy consumption. Widely used in metallurgy, light industry, machinery

, hardware, machinery, electrical appliances, motor maintenance, hardware manufacturing and other sheet metal processing industry. 1 m, 1.3 m, 1.5 m, 2 m foot shearing machine, manpower shear shearing machine high quality, and have light weight, convenient movement characteristics, widely used in sheet metal industry, with reasonable structure, shear automatic reset, and foot light freely, It is equipped with cutting stopper and step bar folding device, cutting quality: even incision, straight edge line, no burrs, to achieve precision cutting effect. Power saving, precision shearing, easy operation, economical and practical. 1 meter electric plate shearing machine has motor driven gear, by foot beam control tool rest swing up and down, has reached the plate shear. This shearing machine has the characteristics of fast cutting, no burrs, low noise, easy to use and maintenance, smooth shearing surface. Foot plate shearing machine refers to the spring with sliding fulcrum fixed, so that its operating force reduced by two thirds, part of the machine tool is equipped with a material pressing device, high shear quality, and has the characteristics of light weight, easy to move, widely used in the metal sheet industry of human shear blanking. No power cutting, reasonable structure, shear automatic reset, foot light and free, with shear stopper and step bar folding device, shear quality: straight incision, straight edge, no burr edge, to achieve precision cutting effect. Power saving, precision shearing, easy operation, economical and practical.

Different kinds of bending machine common fault handling methods

Mechanical bending machine

Fault 1: the guide gap between the slider and the guide rail is too large, causing abnormal sound.

This kind of fault is due to the use of guide rail for a long time, wear lead to the increase of clearance. It is necessary to check the wear degree of guide pressure plate, determine whether to replace the guide pressure plate according to the wear degree, and readjust to meet the requirements of the gap.

Fault two: rear gear transmission failure. The failure of the rear gear transmission is due to the disconnection of the drive shaft from the key bar of the synchronous belt pulley or the slip of the synchronous belt.

This type of failure requires reassembling the key bar and synchronous belt, and checking the electrical part.

Fault three: the parallelism deviation between the straight guide rail of the rear baffle beam and the center line of the mold is too large. This kind of fault needs to loosen the "X" axis synchronous belt, readjust to the tolerance range of parallelism, and reinstall the synchronous belt.

Fault four: the connection between the cylinder and the slider is loose, causing the wrong bending Angle or the machine can not find the reference point.

This type of failure requires rechecking the tightening slider and cylinder nut.

Add liquid 5mm above the filling hole to make the filling hole completely flooded.

2. Check whether the fast forward speed is too fast, causing insufficient liquid filling. You can modify system parameters to reduce the fast forward speed.

3. Check whether the liquid filling valve is fully opened. If it is due to oil pollution, the spool of the liquid filling valve is not flexible and stuck, causing insufficient liquid filling. The filling valve needs to be cleaned and reinstalled to make the spool flexible.

Exit mobile version