100T3200 CNC bending machine maintenance needs, weekly check the oil level of the tank, such as hydraulic system maintenance should also check, oil level below the oil window should be filled with hydraulic oil. Model and hydraulic oil recommended to match the use; System oil temperature should be between 35℃~60℃, not more than 70℃, such as too high will lead to the deterioration of the oil quality and accessories. The oil of the new machine should be changed after 2000 hours of work, and the oil should be changed after every 4000~6000 hours of work. The oil tank should be cleaned each time of oil change.
After the new machine is used for a month, check whether there is any deformation in the bending of the tubing. If there is any abnormality, it should be replaced. After two months of use, the connection of all accessories should be tightened. Monthly clean hydraulic components (substrate, valve, motor, pump, tubing, etc.) to prevent dirt from entering the system, no cleaner.
Every time the oil is changed, the filter should be replaced or thoroughly cleaned. If the machine tool has related alarms or other filter abnormalities such as unclean oil quality, it should be more profitable. The air filter on the tank, every 3 mesh for sound detection cleaning, recommended
1 year replacement.
The synchronization of sliding block is controlled between grating ruler and convincing ratio. The model is equipped with high fine line, and it is used to dry large bending machine and equipment requiring high accuracy of folding. The equipment is the rear stop and sliding block travel line control
System. You can enter you want to bend, and then enter the bending Angle of each step. Just drop the program out when you use it. It will adjust the rear stop distance and Angle of the bend with the step you entered. Hand wheel: Turn the hand wheel to fine tune the distance to the bottom dead point of the slider, adjust the workpiece Angle value, remove the right joint device turn the hand wheel to adjust the parallelism between the bottom dead point of the slider and the workbench, correct the Angle difference between the left and right sides of the workpiece.